Angled Tube Notching Tools
View All Angled Notchers    Arc-Fit Angular    Arc-Snug    Mitre-Snug    Abrasive Belt Coper

Tools for the Fence Industry
View All Fence Tools    Notching Tools    Picket Forming Tool    Picket Forming Video    Pierce Designs in Pickets    Cut Square Tubing    Pierce Channel & Tube    

Other Tube Fabricating Tools
Cut Tubes to LengthPierce TubingV-Notch TubingCustom Dies    Custom Die Sample PartsEndforming / Swaging

Other Vogel Tools
Cut Flat Stock / Rod / AngleHand Press & AccessoriesHydraulic Power Units

Information & Policies
Tool Sharpening ServicesChart: Tubing GaugesChart: Pipe SchedulesChart: Electrical ConduitTerms & ConditionsOrdering & PaymentShippingHours & LocationOrganizationsDealersPublicationsIndustries Served    

Custom Dies

For over half a century, Vogel has specialized in custom dies tailored to your special tube fabricating requirements. Dies shown on this page are just a few of the many types of custom dies Vogel offers. Because these dies are custom built, costs will vary with the application. Please fax us a complete part print showing all part details, tolerances, etc. Please include an estimate of your annual production needs. See some typical examples for special Vogel single and multi-operation dies below.

CUSTOM ARBOR PIERCING DIE

For Piercing a clean hole through 2.5" OD x 1/8" wall tubing. Tube is slide over arbor (mandrel) against end-stop. Hole is pierced through both walls, with slug ejected below lower die shoe. Sharpenable punch, replaceable arbor. Tube is pierced with no deformation to the tube OD.

CUSTOM FLATTEN, RADIUS FORM & PIERCE DIE

To form 1" schedule 40 pipe to bottom wall and form up into radius x 5-1/2" long. A second station pierces a square hole and trims end square.

CUSTOM CENTERLINE FLATTEN AND PIERCE DIE

For 1" O.D. x 16 ga. stainless steel tubing. Creates end configuration, including trimming end square and piercing hole - in one press stroke.

CUSTOM END FORMING DIES

To form and seal one end of a 5/8" O.D. tube with gauging and air ejection in one stroke of the press.

CUSTOM CENTERLINE FLATTEN, FORM, PIERCE, COIN & CUTOFF DIE

For 1/2" O.D. x 18 ga. tubing with automatic gauging and stop. Makes one complete part per press stroke.

CUSTOM FEED-THROUGH DOUBLE FLATTEN, RADIUS TRIM AND PIERCE DIE

Performs all three operations in one press stroke. This feed through design means one end of two parts is made simultaneously. An hourglass shape slug is created when the two flattened ends are cut.

CUSTOM THROATLESS SLOTTING DIE

For slotting round, square or rectangular tubing to unlimited depths. Multiple hits required, depending on desired depth of completed notch.

CUSTOM MULTISLOT™ MULTIPLE SLOTTING DIE

This tool is designed to create multiple slots around the circumference of a tube in one stroke of a punch press, normally used when four or more slots are required and tube ID is sufficient to allow for required mechanism in tube ID. Note that our Arc-Twin tooling can put in two slots, 180° opposed, in tube ends.